אינדקס
CAS STUDIO 8.6c this is how to update your gamma
CAS STUDIO 8.6c this is how to update your gamma cards
using a a plug b plug [a standard printer cable]
*************************************
STEPS for succesfull programming with the cas 3 or the cas3+ programmers
************************************
1 connect power usb cable of cas3 programmer to your pc/laptop
2 open the cas studio software loader panel
3 click the smart card tab on the loader panel
4 next click the gamma card box
5 insert your gamma card chip down in the cas3 card reader
[the card details IE: atr will appear on the panel if card is active]
6 click the folder on the flash bar at the bottom of the panel, to find and load
the file that you have downloaded and taken from the zipped folder ready to load
7 next click the write button on the panel and the file will load onto the card
[the file will over write the earlier file],[if the card new it will load the file on it]
8 you must wait untill you see the file loaded compleatly 100% on the panel
9 then you close and exit the cas studio software panel the card is programmed
and it will now open the channels
************************************
with this new cas studio software from duolabs.com
you dont now need to use the following items to load the gamma card
making it a very easy card to program and less chance of damaging the card ATR
****************************************
NO serial cables
NO usb to 9 pin adaptors for laptop users
NO gamma loaders
but if you want to load with gamma loader or emk you must conect and the serial cable and go to the utilitis press phoenix and press 6mhz and then hide
CAS STUDIO 8.6c this is how to update your gamma cards
using a a plug b plug [a standard printer cable]
*************************************
STEPS for succesfull programming with the cas 3 or the cas3+ programmers
************************************
1 connect power usb cable of cas3 programmer to your pc/laptop
2 open the cas studio software loader panel
3 click the smart card tab on the loader panel
4 next click the gamma card box
5 insert your gamma card chip down in the cas3 card reader
[the card details IE: atr will appear on the panel if card is active]
6 click the folder on the flash bar at the bottom of the panel, to find and load
the file that you have downloaded and taken from the zipped folder ready to load
7 next click the write button on the panel and the file will load onto the card
[the file will over write the earlier file],[if the card new it will load the file on it]
8 you must wait untill you see the file loaded compleatly 100% on the panel
9 then you close and exit the cas studio software panel the card is programmed
and it will now open the channels
************************************
with this new cas studio software from duolabs.com
you dont now need to use the following items to load the gamma card
making it a very easy card to program and less chance of damaging the card ATR
****************************************
NO serial cables
NO usb to 9 pin adaptors for laptop users
NO gamma loaders
but if you want to load with gamma loader or emk you must conect and the serial cable and go to the utilitis press phoenix and press 6mhz and then hide
