Vodka 0.0.4 + mgcamd 1.35 stability problems יציבות שיתוף

Vodka 0.0.4 image in to my cuberevo 200HD, and mgcamd 1.35 EMU, because I'm using cccam sharing protocol.
When I switch on power, the tuner is working steadily for some time, but then starts freezing. After the tuner reloading everything again restored, and again start freezing.
Please give advice where can be a problem, maybe its EMU problem? what EMUs I must to use with cccam server?
Both Incubus and MGcamd perform best to CCcam server 2.011
Higher versions of CCcam server are known to give freezes

same problem with PGI img


mgcamd1.35 is not good running with cccam, but you can use oscam this works better with cccam protocol! Quote:

giedriusm wrote:
I installed Vodka 0.0.4 image in to my cuberevo 200HD, and mgcamd 1.35 EMU, because I'm using cccam sharing protocol.
When I switch on power, the tuner is working steadily for some time, but then starts freezing. After the tuner reloading everything again restored, and again start freezing.
Please give advice where can be a problem, maybe its EMU problem? what EMUs I must to use with cccam server?
With my drembox DM800HD with this cccam server works fine, without any problems

Try to change the mg_cfg

# network ecm timeout in seconds
K: { 01 }

# newcamd dead routes connect retry, sec
Q: { 60 }

# box type
# 00 autodetect, change only if you think wrong type detected.
# 01 dbox2
# 02 dreambox
# 03 triple-dragon
# 04 relook
# 05 openbox
# 06 dreambox/mips
# 08 stapi/kathrein
# 09 stapi/ipbox
# 11 stapi/openbox
# 12 dgs based image/cuberevo-ipbox
B: { 12 }

See if it will help